TNC workpiece measuring with Touch probe system TNC 640

For all TNC 320/TNC 620/TNC 640 contouring controls

Course contents

Fundamentals

  • Setup of touch probes
  • Centering the touch probe
  • Editing the touch probe table
  • Editing the preset table

Touch probe cycles in the manual and electronic handwheel modes

  • Calibrating a touch probe
  • Compensating workpiece misalignment
  • Workpiece presetting

Touch probe cycles for automatic workpiece inspection

  • Automatically measuring workpiece misalignment
  • Automatic presetting
  • Automatically recording measurement results
  • Automatically measuring workpieces
  • Logging tool dimensions
  • Creating freely definable table

Align the plane

  • Manual Operation
  • Define Cycle 431 measure plane

KinematicsOpt

  • Testing and optimizing the kinematics 

Objectives of the course

The participants can apply the touch probe cycles in manual and automatic mode and log the measured values

Target group

Programmers and operators of CNC milling machines, CNC trainers

Requirements

Completion of the Basic Training, or the equivalent knowledge of programming and operating the TNC control

ID: 3136 Number of free places
09.04.2019 - 11.04.2019
Location
HEIDENHAIN Training Center, Traunreut Further providers/locations see button "Training worldwide"
Pricing
Duration
3 days
Tuesday 8:00 a.m. to 
Thursday 4:00 p.m.
Number of participants
Maximum 6
TNC workpiece measuring with Touch probe system TNC 640 For all TNC 320/TNC 620/TNC 640 contouring controls

Fundamentals

  • Setup of touch probes
  • Centering the touch probe
  • Editing the touch probe table
  • Editing the preset table

Touch probe cycles in the manual and electronic handwheel modes

  • Calibrating a touch probe
  • Compensating workpiece misalignment
  • Workpiece presetting

Touch probe cycles for automatic workpiece inspection

  • Automatically measuring workpiece misalignment
  • Automatic presetting
  • Automatically recording measurement results
  • Automatically measuring workpieces
  • Logging tool dimensions
  • Creating freely definable table

Align the plane

  • Manual Operation
  • Define Cycle 431 measure plane

KinematicsOpt

  • Testing and optimizing the kinematics 
S TNC TS EN 09.04.2019 (week 15) 2019-04-09 2019-04-11

HEIDENHAIN Training Center, Traunreut

Further providers/locations see button "Training worldwide"

1170 0