Workpiece counter with engraving NC9025
Workpiece counter with engraving
NC9025
NC program combining a workpiece counter and the engraving cycle 225. The counting function is realized with a table so that the values will not be lost during shut down. If a workpiece quantity that was defined at program start has been completed, this is displayed on the screen and the control resets the counter after the message is acknowledged. The engraving text consists of two parts: a text that you define as a string parameter and the current numerical value that the control reads from the table. The control combines these data in a string. This string is defined in Cycle 225 as engraving text and is engraved on the workpiece at a position that you enter.
Possible with TNC 640 as of NC software no.: 340 59x-02
Possible with TNC 620 as of NC software no.: 734 98x-02
Possible with TNC 320 as of NC software no.: 340 55x-06
Product type
TNC 640
TNC 620
TNC 320
Milling
Milling in 3 axes (X, Y, Z)
Milling in 3 + 2 axes (X, Y, Z + inclined axes)
Milling in 5 axes (X, Y, Z + tilting axes)
Engraving
Tables
NC program
Programming station
Programming station VirtualBox
Machine control
TNC7
