Optimization Controls: Advanced training

• Clarification of the focus of the course
• Repetition: Operating the TNCopt computer software 
• Post-optimization of the control loops
• Working with the bode diagram
• Sequence of automatic controller tuning (ACT)
• Working with the waterfall diagram and working space scan
• Optimizing the nominal position value filters and jerk parameters according to the following criteria of machine dynamics "Fast, Accurate, Surface"
• Determination of MP subfiles and possible solution at the TNC

• Introduction to all Dynamic Precision and Dynamic Efficiency functions with some practical examples for commissioning

   

Please bring your own computer or notebook, which must meet the following requirements:

• Microsoft Windows
• Zip-compatible extraction software
• Authorization to install software
• USB port with removable media access
• Ethernet connection with cable
• Configured network environment (Ethernet TCP/IP)

• PC processor supporting the AVX2 instruction set

   

HEIDENHAIN cannot provide any computers or notebooks for the course.

• The participants are in a position to post-optimize control loops of axes or spindle such that special machine requirements are fulfilled 
• The participants' special problems will be treated, if possible

• Specialists in machine adaptation, commissioning and service from machine tool builders and retrofitters

• Knowledge of operating HEIDENHAIN controls
• Participation in the training "Commissioning and optimization"
  training or profound knowledge of optimizing a digital control loop
• Basic knowledge of operating the TNCopt computer software